Steps for Installing Artificial Grass in Gardens
Ground Preparation: This step is key to ensuring the installation goes smoothly. Do not skip anything—seriously, because if you do not prepare the ground properly, the grass will not sit firmly afterwards and you could run into problems. Here is what you need to do:
Clearing the Area: The first step is to clear the ground. Remove everything in the way: grass, roots, stones… If there are any weeds, it is best to pull them out too, as they can cause headaches later on.
Levelling: Once the area is clear, make sure it is level. Use a rake to smooth everything out properly. If you spot any bumps or dips, fix them, because any unevenness will show up later.
Installing the Weed Membrane This is essential to stop natural grass or weeds from growing through the artificial turf. Lay a weed control membrane flat across the cleared and levelled ground, making sure it covers the entire area. Secure it with pegs or whatever you have to hand so that it stays firmly in place.
Creating the Sub-base To keep the artificial grass firm and prevent it from shifting over time, you need to lay a gravel or sand sub-base:
Spreading the Sub-base: Apply between 3 and 5 cm of gravel or sand across the entire area. Spread it out evenly so the depth is uniform.
Compacting: This is where you need to use a plate compactor or garden roller to firm up the sub-base so it is as solid as possible.
Laying the Artificial Grass Now comes the exciting part: it is time to roll out and lay the turf.
Rolling Out and Trimming: Roll out the artificial grass over your prepared base and trim it to size. Always leave a small margin to make final adjustments later on. Do not worry if there is a bit of excess—it is much better than cutting it too short.
Positioning: Lay it over the base and make sure the joins between the different pieces line up neatly. Watch out: if you are using multiple rolls, check that the pile direction runs the exact same way on all of them, otherwise it can look odd.
Securing the Grass
To stop the turf from shifting over time, it needs to be properly secured:
Using Pegs or Staples: Use U-pins or fixing pegs to secure the grass, placing them every 20 to 30 cm along the edges and joins.
Infill (Optional) If you want to give it an extra touch, you can add silica sand between the blades. This makes the grass look more natural and helps it stay firmly weighed down.
Applying the Infill: Sprinkle the sand evenly and use a stiff broom or power brush to work it in. This helps the grass hold its shape and keeps the fibres standing upright.
Final Brushing To finish off, give it one last brush. This lifts the blades and leaves the lawn looking much more uniform and natural.